Plastic Square Mesh Netting
The joint structure of Plastic square netting is quite different from Extruded Plastic Diamond Mesh. Machine direction strands run the length of the roll and cross direction strands run the width of the roll. Joints are formed at the interesection and are not stacked one over the other as in diamond net mesh plastic netting.
Generally, the machine direction strand is thicker than the cross direction strand. The overall thickness of the netting is typically determined by the machine direction strand thickness. As a result of this joint configuration, plastic square netting usually has one side of the material that is smooth, that is, both the machine and cross strands are flush on the same plane, and one side that is "bumpy", where the machine direction strand has a higher profile than the cross strands.
Square mesh plastic netting is extruded in a wide range of configurations featuring:
- Structural integrity
- Apertures "locked" by fused joints
- Smooth surface on one side
Most products from Industrial Netting are available in bulk rolls or custom cut sizes. Choose from a broad range of apertures and thicknesses - or consult with a representative to help identify a specific product for your intended use. Utilize Industrial Nettings' custom converting services to recieve the specific sized netting for your needs.
Tolerances vary with apertures (hole sizes), weights, thicknesses and widths
Product: XV1340Hole Size (in) 0.095 X 0.175Thickness (in) 0.07Roll Width (in) 39.5Open Area 50%
Product: XV1347Hole Size (in) 0.095 X 0.175Thickness (in) 0.07Roll Width (in) 47.5Open Area 50%
Product: XB0265Hole Size (in) 0.203 X 0.187Thickness (in) 0.059Roll Width (in) 41.5Open Area 60%
Product: XV1170Hole Size (in) 0.25 x 0.25Thickness (in) 0.08Roll Width (in) 48Open Area